Search the Community
Showing results for tags '2.3.5'.
Found 2 results
Hey all. Enclosed in this post is the Motorola Electrify Stock 2.3.5 SBF file. "What does this do?" I hear you ask.. Well listen up and I will tell thee. This will revert your phone back to Stock. This will RELOCK your Bootloader if you have previously unlocked it. (IE it will no longer be Unlocked) It will also remove ROOT and restore all data on all the internal partitions including preinstall, osh, system, etc. It will NOT delete your Data partition, all your apps etc will be intact, but if they needed root access they will obviously lose that.. Now there are some things you must know: 1) It doesnt delete your Data partition, as I stated above - so if you had any apps giving you issues they will still do so. If you wanted to go back to full stock, try and do a Restore Factory first before flashing it so you know you are totally back at stock with no pesky apps giving you issues. 2) You will lose programming on the phone. So even tho it will boot, no data, phone calls, sms until you do a *228 to provision the phone. DO NOT DO *228 IF YOU ARE NOT ON A USCC NETWORK (you have been officially warned) This is handy if you mess up your phone and didnt make a backup of your stock rom (Silly you) or if you need to re-lock the bootloader for a warranty issue. THIS WILL LOCK BOOTLOADER PERMANENTLY! How to Flash: You will need RDSLite 5.5 or higher (you will find them in the unlocking bootloader thread HERE in the zip file) Power off your phone. Hold Volume up and power on until you see RSD Programming mode on your phone's screen Connect phone to USB cable. Put the 1FF-sunfire-user-2.3.5-4.5.1A_SUN_USC_19.0-19-release-keys-signed-USC-US.sbf file into the filename area of RSDLite. Your phone will be shown in RSD Lite, select it and press start.. It took about 10 mins or so - so be patient. RSDLite will show success and your phone will reboot back to stock (notice no more unlock in the top left corner) That's it you are done! Now you can re-root, send to repair, whatever you want... Hope this helps for those who was afraid to flash due to no way of going back! Grab the SBF Here You will need to unrar it before using it. Uncompressed its over 2gb! compressed it down to near 1/2 gb! MD5 checksums are enclosed in the zip so you can check if they are OK too. Enjoy!
Guest posted a topic in Electrify Guides/TutorialsFirst the usual Disclaimer: I do not take any responsibility if anything bad happens as a result of following this tutorial, if you brick your device because something went wrong its not my fault Now that that out of the way time for the steps (all files needed will be attached) Download files first